7 Easy Steps How To Cut A Square Hole In Plywood

This article will show you how to cut a square hole in plywood. It is important to use the right tools and follow safety precautions when working with power tools. If your budget is short and you want to buy the best features miter saw then you can see our another article where we review the budget miter saw under 300$.

How To Cut A Square Hole In Plywood

Step-01

First, you need to find the center of your plywood. Draw a line from corner to corner across the board with a pencil and then use an adjustable square set at half that width (in this case, ½ inch) to draw another perpendicular line through the first one. Use a combination square or tape measure to make sure the lines are perfectly horizontal and vertical.

Step-02

Now measure the height of your home from top to bottom, then use a straight edge ruler set at that distance (in this case the line is ¾ inch) to draw another perpendicular line across the board, making sure it intersects with your center mark. This will be where you drill pilot holes for the jigsaw.

Step-03

An alternative method is to use a hole saw bit that matches your desired diameter and drill through the plywood, but this can be dangerous if you don’t have enough space or clearance above for it to fit. While using one of these bits will give you a cleaner cut than drilling pilot holes first, they are slow and can burn the wood.

Step-04

Finally, it’s time to cut out your board with a jigsaw. You should clamp down the plywood on two sides so that you only have to hold the base steady while moving up and down on top of your cutting line – this is much safer than trying to drill straight lines in the air.

Step-05

The jigsaw blade should be new and sharp, with at least 24 teeth per inch (the more the better). Begin by making your first cut on one end of the line to establish a starting point for cutting straight down from top to bottom. Then make your second cut across the board in order to meet up with where you began.

Step-06

Once you have a corner established, use it as your guide and continue making cuts to remove the excess wood until all of the areas is cleared out. For safety reasons, always keep fingers away from where the blade will cut next so they don’t accidentally get hurt if there are any unexpected snags or jerks in the blade.

Step-07

You can make your square hole slightly bigger than the size of a quarter if you like, but don’t go too much over an inch in radius or it will be difficult to cut out with a router bit and finish up smooth on all sides. If you want any decorative edges around your workpiece, just draw them onto the plywood before cutting out the square.

Can a router cut a square hole?

Yes, a router can cut out square holes in the plywood. You should use the correct tools and safety precautions when using power tools like this one. If you are a pro-level user then you can cut it by using a Reciprocating Saw. In this case, you need the best pruning blade for your device. if want to buy the best pruning blade then you can go to this article.

How do you cut a square hole in steel?

A jigsaw can cut a square hole in steel. You should use the correct tools and safety precautions when using power tools like this one. If you want to buy the best jigsaw blade for metal cutting then you can visit our best Sawzall blade for metal cut. In the article, we are trying to cover some special features that are you really like.

Table of Contents
    Add a header to begin generating the table of contents
    About Larry

    About Larry

    I’ve been fortunate enough to work with wood since I was in middle school. Since then, I’ve worked with a variety of power tools. But now I started Best Saws Point, a blog site that specializes in woodworking tools. I am dedicated to providing the best products reviews and information. 

    Share on facebook
    Share on twitter
    Share on pinterest
    Recent Post

    Leave a Comment

    Your email address will not be published. Required fields are marked *

    Scroll to Top